Honeywell Door 6150RF User Manual

K4461-1V1 4/05 Rev. A

ADEMCO 6150RF

Keypad/Transceiver

USER GUIDE

Keypad Features

DISPLAY

The keypad features a 2-digit numeric display for zone identification and pre-designated English-

language prompts (e.g., “ALARM,” “AWAY,” “STAY,” “CHECK,” etc.) for indicating system status. See

Figure 1.

FUNCTION KEYS

The function keys are located behind a decorative door and are continuously backlit for ease in use.

(Check the User’s Guide that accompanies the control panel for detailed instructions on the use of these

keys.)

The function keys include keys for panic alarm activation. The panic alarms are activated by pressing

key pairs [1] & [*], [3] & [#], or [*] & [#], or a Special Function Key (see below). Whether these panic keys

function and the type of panic alarms they produce is determined by the control panel’s capability and

programming. (Check with your installer for the availability and type of alarm of these panic keys.)

SOUNDER

The sounder is a piezo-electric sounder that pulses for fire alarms and generates a two-tone sound for

burglary and audible panic alarms.

KEYPAD LEDS

The keypad contains two LEDs that indicate the status of the system as follows:

LED

Function

Green

Red

Lights when the system is ready to arm (no zone faults are present).

Lights when the system is armed.

SPECIAL FUNCTION KEYS

These are four keys located to the left of the numeric keys (see Figure 1). The keys may be programmed

by your installer for panic alarms or other special functions such as macros (a frequently used series of

key entries). Function keys must be held down for at least 2 seconds to activate an alarm.

(Check with your installer for the programmed function of these keys.)

ARMED

READY

OFF

MAX

AWAY

TEST

CODE

STAY

BYPASS

CHIME

INSTANT

READY

Figure 1: ADEMCO 6150RF Keypad/Transceiver with Front Door Removed