Havis Shields Window WGI F11 User Manual

INSTALLATION INSTRUCTIONS

INTERIOR WINDOW GUARD KIT

MODEL WGI-F7 1998-2007 FORD CROWN VIC

MODEL WGI-F11 1994-1997 FORD CROWN VIC

TOOLS REQUIRED:

Eye Safety Goggles

Power Drill

1/8” Drill Bit

Phillips Screw Driver

HARDWARE SUPPLIED:

QTY

DESCRIPTION

PART #

#10 x ½” Phillips Sheet Metal Screw

Driver Side Window Guard

Passenger Side Window Guard

GSM33194

WGI-F7-1 or WGI-F11-1

WGI-F7-6 or WGI-F11-6

INSTALLATION:

1. First determine the correct window guard for each window. The bottom of each guard is

numbered, signifying its’ location.

2. Open door and hold the window guard up to the window door frame. NOTE: The angle at the

bottom of the guard framework faces towards the outside of the car. The guard framework fits

evenly around the window frame.

3. Mark a few holes at the top of the door frame using the pre-drilled holes on the guard framework

as a guide.

Note: Do not mark holes for the sides or bottom yet.

4. Remove window guard and drill holes as marked with a drill bit.

5. Attach window guard by using #10 x ½” sheet metal screws. Now locate and mark balance of

holes, drill and attach, starting at top and working your way down.

6. Follow the same steps for the other side of the vehicle.

WGI-F7-F11-INST-9-06