Havis Shields Automobile Accessories C 3619 User Manual

Installation Instructions C-3619

MOTOROLA MW800/MW810 CPU TRUNK MOUNT

1995-2009 FORD CROWN VICTORIA

DRIVER SIDE TRUNK CPU BRACKET:

• Remove driver side taillight.

• Position CPU Mount bracket so holes in bracket line up w/ taillight

mounting holes.

• Reattach taillight through holes in bracket, then loosely attach nuts.

• Drill ¼” holes through vehicle trunk frame wall on opposite side of

bracket. Use front side of bracket as a drill guide.

• Attach ¼-20 x ¾” Hex head bolts and ¼” Serrated nuts.

• Tighten all hardware.

• Mount CPU to Housing bracket using (4) 5mm-.8 x 10mm Hex

head machine screws and washers. Be sure ON/OFF switch on

CPU is turned ON at this time.

• This housing will be mounted to CPU Bracket after CPU cables

are attached and wiring is complete.

ATTACH CABLES TO CPU:

• Data cable from monitor to Display 1.

• Speaker cable box to port labeled AUX and Audio Out

• Ignition sense cable attaches to Speaker cable box.

• Route antenna cable to CPU

• Attach antenna connector to antenna cable

• Leave a service loop and wire tie antenna cable to CPU cover.

• Now that all cable is attached and wiring is complete attach CPU

Housing to CPU bracket using pem-studs and ¼” serrated nuts

designated for the specific components.

• CPU cables will face Rear Passenger Side taillight when mounted

then loop down and around computer, up the inner wheel well, to

the back seat wall.

• CPU must be level, both vertically and horizontally, to meet

Motorola standards.

• Place CPU cover (CM93625) on mount using 10-32 x ½” Machine

screw.

C-3619_INST_12-08