Hampton Direct Router Appendix C User Manual

appendix C

Router Table Handles

Determine height for pattern bit.

Thickness of tail board

Trim stock or spacer

At least 1/16" of bearing

must extend above base

of router table.

Pattern bit depth

1/2" for guide forks

Base of router

table

Routing Pins and Tails

Grasp the router table handles on the side opposite the board that you wish to

route, and slide the KATIE JIG™ System toward the bit. Carefully route the

areas between each of the guide/ tuning forks.

CAUTION: DO NOT lift the KATIE JIG™ System while the router is running!

Slide fixture toward bit

Page C-2